Systems Deployment Question

Error on Apply Image task when booting to new KBE environment

11/07/2018 826 views

I created a new KBE environment, because we had to add new WinPE drivers for our new model.

Any time I boot to that environment, and try to deploy an image, the job fails at the Apply Image task.

If I boot to the old environment, with a different machine, that task runs fine.

The error I  receive gives me the return code 4294967295 and error description "Unknown error".

Has anyone seen this before?

1 Comment   [ + ] Show comment


  • Did you check the BIOS for the hard drive settings? The new model might be defaulting to a different setting (e.g. RAID, SATA, etc.) than the previous machines.

    Are you deploying a WIM image of a K-Image or performing a scripted install?

    Before running your workflow, can you use the command prompt to make sure that the c: drive is visible?

All Answers


You most likely downloaded the 1809 adk to make your boot.  You need to stick to the 1803 ADK till 6.1 goes GA.  MS made changes in 1809 that  Kace has to adapt to.  If you need drivers that are not in the 1803 boot.wim you will need to inject with dism prior to making your KBE

Answered 11/08/2018 by: SMal.tmcc
Red Belt

This website uses cookies. By continuing to use this site and/or clicking the "Accept" button you are providing consent Quest Software and its affiliates do NOT sell the Personal Data you provide to us either when you register on our websites or when you do business with us. For more information about our Privacy Policy and our data protection efforts, please visit GDPR-HQ