10/28/2009 2679 views
I have been on this site and looked at the WinZip 12 setup information:


All of the tweaks for v12 seem to work for v14 as well but what I can't silence is the "WinZip Setup" I run my MSI with custom MST file and it installs but then at the end of the install a "WinZip Setup" window pops up asking me to "Choose Classic or Wizard" then click Next.

How do you silence this wizard?
0 Comments   [ + ] Show comments


Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

All Answers

My guess would be that you need to capture whatever that Wizard changes and add those changes to your MST. I figure you'll only need to use a snapshot tool (e.g. InstallWatch) as they're likely to be registry entries.
Answered 10/29/2009 by: VBScab
Red Belt

Yes, I was able to automate it. I was just wondering / hoping there was a command line switch that would address this for you. Thanks.
Answered 10/29/2009 by: mhsl808
Fifth Degree Brown Belt

Did you check for a custom action?
Answered 10/29/2009 by: AngelD
Red Belt