/build/static/layout/Breadcrumb_cap_w.png

K2000 and HP x360 Imaging

Good Morning,

Unfortunately they want us to test deploying HP systems through Kace.  I have the driver structure setup in the K2000 for the post install.

When I boot the HP x360 and press F12 to boot from network, the screen displays "Start PXE over IPV4. Pres [ESC] to exit" for a few seconds then boots to windows.  It does not seem to get an IP on boot.

I can hook the same network wire into a Dell and it boots to K2000 without issue.  So I know the network is working.

Any help appreciated.

Thank You
Asked 8 years ago 1421 views
0 Comments   [ + ] Show comments

Answers (1)

Posted by: nheyne 8 years ago
Red Belt
0
Your device is set to UEFI boot to nic, and the K2000 does not support UEFI booting yet.  You'll need to perform a Legacy boot to nic.
Comments:
  • Worked like a charm! I sure did not want to mess with HP stuff. - m698322h 8 years ago
 
This website uses cookies. By continuing to use this site and/or clicking the "Accept" button you are providing consent Quest Software and its affiliates do NOT sell the Personal Data you provide to us either when you register on our websites or when you do business with us. For more information about our Privacy Policy and our data protection efforts, please visit GDPR-HQ