/bundles/itninjaweb/img/Breadcrumb_cap_w.png
Hi Guys,

This applicaiton has setup.exe. When I run the install it extracts 22 msi's in installer directotry. I can't wrap all the 22 msi's, is there any best solution for packaging this guy. I also checked silent switch( /?,/s,/q,/silent,...etc) but none of them are working.
I am using installshield.

Thanks,
0 Comments   [ - ] Hide Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.
Answer this question or Comment on this question for clarity

Answers

0
I can't wrap all the 22 msi'sWhy not?
Answered 06/09/2010 by: VBScab
Red Belt

Please log in to comment
0
dono the install sequence.....
Answered 06/09/2010 by: bulbul
Senior Purple Belt

Please log in to comment
0
There *must* be an INI or some such which the existing installer uses, no?
Answered 06/09/2010 by: VBScab
Red Belt

Please log in to comment
0
there is an INF file. but I couldn't find the proper sequence. This .inf file is more than 1000 lines..I am trying to see the sequence of msi's. I can't even paste the inf here..
Answered 06/09/2010 by: bulbul
Senior Purple Belt

Please log in to comment
0
check the uninstall string for clues as per the order in which the msi's are installed
Answered 06/09/2010 by: cygan
Fifth Degree Brown Belt

Please log in to comment
0
The INF contains information about the drivers, not the install sequence.

Does the installer allow logging? If so, the log will hopefully show the sequence.
Answered 06/10/2010 by: VBScab
Red Belt

Please log in to comment
0
I am goign to try this also..
Answered 06/10/2010 by: bulbul
Senior Purple Belt

Please log in to comment