What should I do when PXE Configuration Utility reports "not installed properly" after installation?

0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
It has been found that after installing PXE and then running the configuration utility, Deployment Server may erroneously report that it is not installed properly. This situation was reproduced often in Deployment Server 6.5 and in most cases a second launch of the configuration utility was successful. In one case it took a couple of minutes before it was successful. It is assumed that after installation, it may take a couple of minutes before the installation is fully complete and ready for configuration (even after you are notified the installation completed successfully).
Answered 04/25/2006 by: bkelly
Red Belt

Please log in to comment
Answer this question or Comment on this question for clarity

Share