What do i need to change in the mst file to get it to "complete install" when installing silently

at the moment i can only get it to install as a "typical install"
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
Check the value of the property InstallMode in the property table of your msi (I think it would be Typical). You may change this value to Complete.
Answered 02/25/2008 by: India_Repackaging
Blue Belt

Please log in to comment
0
Installmode is already set to Complete, but its not installing as complete.

Anymore ideas?
Answered 02/25/2008 by: dan0
Senior Yellow Belt

Please log in to comment
0
ORIGINAL: dan0
What do i need to change in the mst file to get it to "complete install" when installing silently
The best way to create transforms for all Office products is to use the appropriate Customisation Wizard. There are some notes about Visio 2003 and a link to the Office 2003 Customisation Wizard here http://itninja.com/link/kbq2600902
Answered 02/26/2008 by: VBScab
Red Belt

Please log in to comment
0
I have read that and created the mst file via the customisation wizard... it does not give a specific link to choose whether to do a complete install or typical.
Answered 02/26/2008 by: dan0
Senior Yellow Belt

Please log in to comment
Answer this question or Comment on this question for clarity