Hi All,

I today installed a K1000 trial virtual appliance, and I am trying to configure the device to be discovered by my SNMP tool.

But I goto Control Panel, Security Settings where I thought SNMP was setup, but there isnt any area where it can be configured?

Is this disabled becuase of the trial or because of the virtual appliance?

Am I looking in the correct area?

Thanks in advance,

Nat
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
It is found under Security Settings :)
Answered 02/22/2012 by: scottlutz
Orange Senior Belt

Please log in to comment
0
Not sure about the trail, but here's a screenshot of a virtual appliance.

Answered 02/22/2012 by: dchristian
Red Belt

Please log in to comment
0
Thanks all for the responses.

Actually after speaking to my Dell rep. I found that SNMP is disabled in a trial license and so I got a new key....hey presto SNMP config became available.

Nat
Answered 02/22/2012 by: natalron
Yellow Belt

Please log in to comment
Answer this question or Comment on this question for clarity