Hi guys,

I have some problems with the silent installation of the openedge 10.2a Shared Network Installation.

i read some installation documents from the company but these parameters didn't work.
Have any one a idea how i could solve these problem.

The installation package is an installshield exe. and the parameters with a .iss also didn't work

BG
Phil

1 Comment   [ + ] Show Comment

Comments

  • too late for you, probably but 10.2b uses slightly different switches.  It prefixes the standard installshield switches with psc_ (and also uses a slightly older variation of switches than mentioned in this thread, so:

    -psc_r  (not /r) to record a response.ini (not .iss)
    -psc_f2="path and filename" to specify a reponse.ini to record or use
    -psc_s    for a silent install with a response.ini
    -psc_f2="path to file and name"    for a log file

Please log in to comment

Answers

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.
0
Have any one a idea how i could solve these problem.



Answered 03/16/2012 by: andemats
Second Degree Black Belt

Please log in to comment
0

hi,

i wanted to run the installation silent. but when i wanted to run the installation with some installshiled parameters. The setup starts normally with the UI.

I execute the installation with following parameters: -s /f1="path to iss file", or -psc_s -psc_f1=path to response.ini file,

everything i tried it didn't work. :(

When i start the installation with the .iss file the log file shows me no error.

Answered 03/16/2012 by: PhilMalle
Senior Yellow Belt

Please log in to comment
0

Phil,

have you tried setup.exe /s /f1"<path to iss file>" /f2"<path to log file>" ?

This would be the standard notation of InstallShield.exe parameters. Not sure if the quotes are needed if there are no spaces in the path...

PJ

Answered 03/16/2012 by: pjgeutjens
Red Belt

Please log in to comment
0
Not sure if the quotes are needed if there are no spaces in the path


required
Answered 03/16/2012 by: andemats
Second Degree Black Belt

Please log in to comment
0

Hi PJ,

yes i tried everything i found on the internet. Nothing works, :(

I have the installation documentation of the sofware but, this also does not work...

Phil

Answered 03/26/2012 by: PhilMalle
Senior Yellow Belt

  • Dis you get anywhere with this in the end Phil

Please log in to comment
Answer this question or Comment on this question for clarity