Service wont start
Im installing a product which has a service. I have an msi, and also a language tranform. When I install the product, it installs fine, and the service starts as it should.
When I install the product with the transform (the tranform only changes strings in the installer), the installer stops with an error 1920, and says that the service cannot be started. But it works fine without the tranform, any ideas?
When I install the product with the transform (the tranform only changes strings in the installer), the installer stops with an error 1920, and says that the service cannot be started. But it works fine without the tranform, any ideas?
0 Comments
[ + ] Show comments
Answers (4)
Please log in to answer
Posted by:
pgiesbergen
15 years ago
Your post does not say if you are using Wise, but if so, Wise is known to sometimes screw up when saving an MST. You should try to create the transform using ORCA or instEd.
Posted by:
anonymous_9363
15 years ago
Run ProcMon (or your favoured process/file/registry monitor) as you start the service and it will tell you what's going on.
Posted by:
kristjan84
15 years ago
I managed to get this fixed by using procmon (thanks VBScab). I had a file which only installed when the product language property was set to 1033, so when i installed another language, the service would not start since it did not find this file
Rating comments in this legacy AppDeploy message board thread won't reorder them,so that the conversation will remain readable.