I recently upgraded to Wise Package Studio 7. I have been creating transforms for packages without issue, but capture installations are showing this behavior. It seems even if I leave the hide repair button unchecked or even set the property ARPNOREPAIR =0 there is no repair button available in add/remove applet. I am alittle baffled on why this is happening only on the capture install.
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
Check the property table and if the ARPNOREPAIR property is present, whatever it's value, then remove it altogether from the table and then retest.

Let us know your findings [:)]

Regards,

Spartacus
Answered 10/25/2006 by: spartacus
Black Belt

Please log in to comment
0
I did verify the entry doesn't exist. Still no Repair, I am sure it is staring me in the face I just not seeing it.
Answered 10/25/2006 by: caberts
Yellow Belt

Please log in to comment
0
Does the NoRepair DWORD reg entry with a value of 1 exist under HKLM\SOFTWARE\Microsoft\Windows\CurrentVersion\Uninstall\<{ProductCode}>?
Answered 10/25/2006 by: AngelD
Red Belt

Please log in to comment
0
When you have the WSI or MSI opened with the Windows Installer Editor, look in the following location for the options you are talking about:

Under Installation Expert
Add/Remove Programs
you have the options to hide the modify, repair and remove buttons.

Check to see if any of those options are checked.

KJ

Wise Packager
Answered 10/27/2006 by: kj_95376
Senior Yellow Belt

Please log in to comment
0
KJ,
Please read the whole post; this has already been noted by spartacus.
The ARPNOMODIFY, ARPNOREPAIR & ARPNOREMOVE properties are set by checking or unchecking the options in Installation Expert -> Add/Remove Programs.
Answered 10/28/2006 by: AngelD
Red Belt

Please log in to comment
Answer this question or Comment on this question for clarity