Hi,

I am working on MS Project 2003 Standard. It is to be made a 'Complete' install however the dialog shows 'Typical' installation.
I have set all features to install.
I want the 'Complete' installation to be checked in the Type of Installation dialog box.
Is there any property or anything else which changes this and shows 'Complete' checked?
Property InstallMode is set to Complete.
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
1) Take as log.
2) when u check complete manually, open log file and u will get to know which property is being set. change it's value/you can use installtailor also.
3) you can try 1 more thing, when you install your source wit complete checked, take a log of installation, in that log file you will get addlocal property with it's value. just add this property in your mst with the value.
Answered 08/27/2009 by: abking99
Second Degree Blue Belt

Please log in to comment
0
It's much, MUCH simpler to open the MSI in an editor, locate the control in the 'Control' table via the 'Dialog' table and note the property "behind" the control.
Answered 08/27/2009 by: VBScab
Red Belt

Please log in to comment
0
VBScab, sometimes it's about the journey not the destination. [:D]
Answered 08/27/2009 by: turbokitty
Sixth Degree Black Belt

Please log in to comment
0
:)

On that basis, my posts could run to pages and pages...
Answered 08/27/2009 by: VBScab
Red Belt

Please log in to comment
0
Change the Property InstallMode=Complete to InstallMode=Custom
Answered 08/27/2009 by: michaelnowell
Second Degree Blue Belt

Please log in to comment
Answer this question or Comment on this question for clarity