Can anyone help ?

I'm using InstallShield12 and creating a simple BasicMSI project.
I have a single system search that loads a public property (all uppercase) with a value from the registry.
I have a VBScript CA that prints this property value to the screen in both the UI and exec sequences, just after AppSearch.

My problem is:

If I run this installation on a machine where the logged in user has full admin rights it all works as expected.
If I run this installation on a machine with "Always Install with Elevated Privilidges" and the logged in user does not have admin rights, the property value is shown correctly in the UI sequence, but is blank in the exec sequence.

Has anyone seen this before ? Does anyone have any ideas on how I can persist a property value between the UI & exec sequences for a non-admin user ?
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
Does the registry key value require admin rights to read it?
Answered 08/11/2006 by: brenthunter2005
Fifth Degree Brown Belt

Please log in to comment
0
Hi Richard.Hewett,

just put your sequence on exec sequences, this will run either on UI or silent mode.

Hope this helps =)
Answered 08/15/2006 by: knight
Orange Senior Belt

Please log in to comment
Answer this question or Comment on this question for clarity