/bundles/itninjaweb/img/Breadcrumb_cap_w.png
I have the following instructions on doing a commandline silent install of Citrix EdgeSight 4.2:
[left]Msiexec /i \\servername\share\EdgeSightEPAgent /l Install_LOG.log /q[/left][left]COMPANY=MyCompany SERVER_NAME=myServer REMOTE_SECURITY=0[/left]SYNCH_AD_TREE=1

I'm using Orca to try and put this into an MST. While I found remote_security and synch_ad_tree parameters in the Property Table and changed them, I cannot find where to enter company or server_name, and, searching the MSI doesn't find them.

Doing a manual install, those two parameters come up as shown:



and



Being kinda a newbie at doing this...how do I determine where to enter these two parameters so that I can make an MST?

Thanks!
0 Comments   [ - ] Hide Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.
Answer this question or Comment on this question for clarity

Answers

0
Sorry...I tried pasting screenshots, but, they didn't appear.

Basically, it's a typical GUI install, asking you to fill in the blank for Company and Server Name. I just can't find corresponding entries in the MSI, to make an MST with.

Thanks.
Answered 02/28/2008 by: gmouse
Orange Senior Belt

Please log in to comment
0
These will be properties "behind" dialog controls, that's why you couldn't find them in the Property table. Have a look in the 'Property' column of the 'Control' table: you should find the properties there.

If you create and populate these two properties as new rows in your MST's 'Property' table, you'll find that the relevant dialog text-boxes will appear (during your testing) pre-populated with whatever values you assign to the properties.
You can then be assured that the silent install will proceed as expected.
Answered 02/28/2008 by: VBScab
Red Belt

Please log in to comment
0
Thanks.

Yes, I saw them in the Control Table, but, didn't see a field to modify in that Table.

Soooo...the CORRECT thing to do is to add them to the Property Table, with the right values, or, is there a better way?

Also...if phrases have spaces, do I ever need to use "", in an MSI?

Thanks, again!
Answered 02/28/2008 by: gmouse
Orange Senior Belt

Please log in to comment
0
ORIGINAL: gmouse
Soooo...the CORRECT thing to do is to add them to the Property Table, with the right values, or, is there a better way?
Correct.

ORIGINAL: gmouse
Also...if phrases have spaces, do I ever need to use "", in an MSI?
Not in the MSI itself, no. Well, unless you want quote marks in the text, of course! :)
Answered 02/28/2008 by: VBScab
Red Belt

Please log in to comment
0
OK, THANKS!

I'll give it a try.
Answered 02/28/2008 by: gmouse
Orange Senior Belt

Please log in to comment