Hello,
Since the updates in the K1000 5.5, the cmd script no works. (Only .bat is ok.)
So beware if you run the updates.

Kace I hope will give us a patch quickly.

0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Answers

1

In case anyone stumbles upon this thread, a Hotfix has been released.  

http://www.kace.com/support/resources/kb/solutiondetail?sol=SOL116901

Answered 12/27/2013 by: davidrnoble
White Belt

Please log in to comment
1

Hi,

workaround solution is using this command:
cmd /c start yourfile.cmd 

Answered 09/20/2013 by: stéphane.t
White Belt

Please log in to comment
1
Hi,

workaround solution is using this command:
cmd /c start yourfile.cmd 

 Yes for one script. But if you have dependency in your script it not works.

I'have test this : cmd /c start /wait yourfile.cmd but is not good same.

 The best solution is rename cmd in bat. But is very hard when you have lot of packets.

 

Answered 09/23/2013 by: nekkar
Senior Purple Belt

Please log in to comment
0

For anyone who has this issue, please submit a support ticket.  The more people that report this, the quicker a patch should be developed: http://www.kace.com/support/contact

Answered 09/20/2013 by: jknox
Red Belt

Please log in to comment
Answer this question or Comment on this question for clarity