If you have an MSI and you just want to take all the defaults, there is no reason to build an MST, correct? I mean if you use "/qb!", that will force all defaults for the MSI, correct?
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
If you just want the defaults then just call the MSI with a /QB or /QB! ... the defaults are used...

Transforms are used if you want to make a change... since no change is need, no transform is needed
Answered 05/01/2007 by: gmorgan618
Blue Belt

Please log in to comment
0
not entirely accurate..

if you are using /qb! you are dropping the installUiSequence as such you may have some "defaults" set in there which are no longer set in your quiet mode installation.

so although gmorgan was right there is a little more to it.
Answered 05/01/2007 by: jmcfadyen
Fifth Degree Black Belt

Please log in to comment
0
Might be beneficial to include a transform which has LIMITUI=1 and/or ALLUSERS=1 (depending upon your install requirements/situation)
Answered 05/02/2007 by: JdotQ
Senior Purple Belt

Please log in to comment
Answer this question or Comment on this question for clarity