I have a package for Sophos encryption that uses a vbs to execute some checks, then 2 MSI's. Installs fine outside of the KBOX environment, however when packaged as a post install "application", there is an error executing the VBS. The command line is "install.vbs"
Any suggestions for a correct command line would be appreciated.
0 Comments   [ + ] Show Comments


Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.


in the past i have used a bat file to execute the vbs script
Answered 07/29/2010 by: CordlezToaster
Purple Belt

Please log in to comment
Since this is the way you would run it from a command line, you could try putting the following in a batch file, then package the batch file with the 2 MSIs:

cscript install.vbs

Answered 12/01/2011 by: jverbosk
Red Belt

Please log in to comment
Answer this question or Comment on this question for clarity