[:@] Hello,
I'm using Dpinst to pre-install a driver for an USB to RS232 convertisser.
The driver installation is working when I connect the device, but abord if the user is not admin of the computer.
Is there a way to do the installation with a user without admin rights?
The blocking seem appearing during the creation of the COM virtual port.
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
Is the driver (.CAT file) signed?
Answered 10/01/2008 by: AngelD
Red Belt

Please log in to comment
0
No. The cat is unsigned.
Do you think that's the problem?
Answered 10/01/2008 by: DEW
Senior Yellow Belt

Please log in to comment
0
The driver must be signed for it to be installed without any admin-credentials during installation from the DRVSTORE (DriverStore on Vista).
Answered 10/02/2008 by: AngelD
Red Belt

Please log in to comment
Answer this question or Comment on this question for clarity