I'm running a VB Script which runs even during installation.But my script should run only while uninstalling.It shouldn't run while installing Can any one help me with the condition.
thanks
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
Condition should be REMOVE="ALL"
Answered 06/21/2010 by: milindsm
Blue Belt

Please log in to comment
0
Answered 06/21/2010 by: MSI*
Senior Yellow Belt

Please log in to comment
0
Condition should be REMOVE="ALL"I tend to go with REMOVE~="ALL" but then I'm a crashing pedant. :)
Answered 06/21/2010 by: VBScab
Red Belt

Please log in to comment
0
REMOVE~="ALL"

Can you explain how it is different from REMOVE="ALL" ?? Just for my knowledge...!! I was not aware of this...!! :(
Answered 06/21/2010 by: milindsm
Blue Belt

Please log in to comment
0
The ~ makes it not case sensitive.

Therefore the remove could:
=ALL
=All
=all
=ALl

etc.

Thanks,

Dunnpy
Answered 06/22/2010 by: dunnpy
Red Belt

Please log in to comment
0
I was not aware of this.MSDN is...
Answered 06/22/2010 by: VBScab
Red Belt

Please log in to comment
Answer this question or Comment on this question for clarity