Hi!

 

I'm new to Kace and am trying to deploy a WIM image harvested from a Dell Optiplex 790. I harvested both C and D Drves. The image seemed to pull to the server fine. I'm running version 3.5. I created the 3 scripts in the creating a 100mb partition guide and placed them in the image. When I deploy it starts and I can see it running through the scripts but then it fails. It's too quick to see anything in the command prompt window. It says failed. See log for errors and it shows a deploy log on the screen but it's blank. I'm not sure what i'm missing. Any help would be greatly appreciated.

 

0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Community Chosen Answer

1

the log file is in \\k2000\petemp.  there are some numbered logs there hover over your deployment and look at the number at the bottom of browser, that is the log file number

Answered 05/15/2013 by: SMal.tmcc
Red Belt

Please log in to comment

Answers

0

Hi!

Ok. I found the log but it did not contain any info from the failed deploy. It only contained info on the capture which was succeessful.

Answered 05/16/2013 by: Chadg001
Second Degree Green Belt

Please log in to comment
Answer this question or Comment on this question for clarity