Currently I have my Dell servers boot to a WinPE ISO stored on a network share. All systems are on a Gigi backbone. From the moment it starts to load WinPe it takes approximately 10 minutes before it completes the WinPe load.

Any ideas how I can trim down the load time?
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
Have you tried using the peimg /prep command before you make your ISO to remove unused packages from the base image?
Answered 10/08/2008 by: Amerit99
Senior Yellow Belt

Please log in to comment
Answer this question or Comment on this question for clarity