avoid custom action during repair?
Hi Guys,
After my MSI is installed ( and restarted) it goes into repair. I wouldnt mind it going to repair, but it then triggers my custom action ( which runs an exe). Due to this my package is going into a loop.
Is there a way to avoid triggering the custome action when an MSI goes to repair??
For example, if i do not want the custom action to run during uninstallation, we specify NOT REMOVE="ALL".
Is there a similar way for avoiding the triggering of the custom action during repair?
Help ! many thanks
After my MSI is installed ( and restarted) it goes into repair. I wouldnt mind it going to repair, but it then triggers my custom action ( which runs an exe). Due to this my package is going into a loop.
Is there a way to avoid triggering the custome action when an MSI goes to repair??
For example, if i do not want the custom action to run during uninstallation, we specify NOT REMOVE="ALL".
Is there a similar way for avoiding the triggering of the custom action during repair?
Help ! many thanks
0 Comments
[ + ] Show comments
Answers (3)
Please log in to answer
Posted by:
spartacus
15 years ago
You could try setting a condition of
NOT REINSTALL AND NOT REMOVE~="ALL"
Regards,
Spartacus
NOT REINSTALL AND NOT REMOVE~="ALL"
Regards,
Spartacus
Posted by:
gomtesh
15 years ago
Spartacus and Inabus,
It didnt work. However the following condition works perfectly fine
Not Installed AND NOT PATCH.
Appreciate all your help.
It didnt work. However the following condition works perfectly fine
Not Installed AND NOT PATCH.
Appreciate all your help.
Rating comments in this legacy AppDeploy message board thread won't reorder them,so that the conversation will remain readable.