Hi all,

When running custom actions you can set them to run at certain points with certain conditions,

I know REMOVE="ALL" will only run on uninstall and apparently REMOVE<>"ALL" is meant to run only on install.. if im wrong so far please inform me!

I have packaged one app, and it calls back to the msi for some current user registry settings it also runs the few custom actions i have running, i would like to stop my custom actions running when this occurs and for them to only occur on a brand new installation.

If that makes no sense please say so :)
0 Comments   [ + ] Show Comments


Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.



If you want your CA to only run on when the package is installed and NOT on a repair or removal then you should use the condition NOT Installed.
Answered 09/27/2005 by: TomB
Orange Belt

Please log in to comment
Hi TomB,

Thanks for the info! [:)]

Answered 09/27/2005 by: ryath
Orange Belt

Please log in to comment
Answer this question or Comment on this question for clarity