I have put my RSA onto XenServer 6.0.2 using XenConvert from the .OVF.  After an initial issue where I have to run the command "ufs:/dev/ad0s1a" to get the box started, I can login using the default credentials and assign an IP address.  After this the devices reboots and comes back online, again I enter the command "ufs:/dev/ad0s1a" and I am back at the login prompt.  However, I am unable to gain access to the box via http, or ping.  All of the network settings are correct on the RSA, and the switch etc are configured without complain as other guests on XenServer are working.

Has anyone got their RSA running on XenServer, and if so did you get any of the above and how did you get around it ?

Thanks in advance

0 Comments   [ - ] Hide Comments


Please log in to comment

Answer this question or Comment on this question for clarity



Before anyone else goes down this route, the response I have had from KACE support is "Virtual KBOX is not supported on XenServer at the moment".

Answered 05/31/2012 by: pentopg
Senior Yellow Belt

Please log in to comment