Transform
I have created a transform for a very simple .msi, but when I run the msiexec command with the TRANSFORM="filename.mst" I always get an "invalid or missing key" error. I run the transform file through the Editor Wizard and the key is showing up and is correct. Any ideas?
0 Comments
[ + ] Show comments
Answers (3)
Please log in to answer
Posted by:
pmarshbu
13 years ago
It is TRANSFORMS="filename.mst" instead of TRANSFORM="filename.mst".
Posted by:
bearden3
13 years ago
BTW, the word "transforms" is not case sensitive; msiexec will read it either way upper case or lower case.
Posted by:
mwcapps
13 years ago
Thank you! Who would've thought that one little "s" could make all the difference.
Rating comments in this legacy AppDeploy message board thread won't reorder them,so that the conversation will remain readable.