I have checked the packages repository and see there are a few methods for Visio Viewer. It all makes sense, but I am having a little trouble...

I have extracted the vviewer.exe file to a directory and moved everything to a network directory.
Using Wise Package Studio 5.52 I have created a Transform file with the InstallTailor.

I have added the following properties:

ACCEPTEULA (set to 1)
ASSOCIATE (set to 1)

However, when I run this MSI and MST together I get an error stating "The EULA was not accepted"

Any ideas as to what Im doing wrong?
0 Comments   [ - ] Hide Comments


Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.
Answer this question or Comment on this question for clarity


Why did you create a transform? What should it do?

Have you tried the original MSI alone without the transform?

msiexec /qb /i your.msi ALLUSERS=1 ACCEPTEULA=1 ASSOCIATE=1
Answered 12/29/2005 by: WiseUser
Fourth Degree Brown Belt

Please log in to comment
Actually I found the problem.... I didn't create an admin install of the original MSI. Once I did that and answered the EULA in the admin install, it worked great.

But that brings up another question I have.... If I'm using GPO to deploy software...where I can only use MSI's and MST's, what is the best way to invoke a command line like that? I see lots of people using command-line solutions to install software but if I'm limited to an MSI/MST, how can I use these command-lines?
Answered 12/29/2005 by: sixdoubleo
Senior Yellow Belt

Please log in to comment
As I understand it, adding ALLUSERS=1 ACCEPTEULA=1 ASSOCIATE=1 to the property table in your transform is the equivalent of the above command line.

I guess you'd use the command line for testing purposes.
Answered 12/30/2005 by: meastaugh1
Senior Purple Belt

Please log in to comment