/bundles/itninjaweb/img/Breadcrumb_cap_w.png
Hi All,

i posted this question on symantec site, but got no reply so far. i was wondering if someone here could help.

made a package in wise 6.2, i get 1904 error only when the installer runs on the clean OS for the first time, if i run it for the second time the installation goes on ok and all the dll files get registered.
I tried to remove selfreg entry and use CA to register all the dlls using regsvr32, but did not help. It is just the first time i run the installer i get the error1904, any idea why this happens.
If i try manually registering the dll's all get register or if other software is installed i do not have this issue.
0 Comments   [ - ] Hide Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.
Answer this question or Comment on this question for clarity

Answers

0
I would hazaard a guess that the files are being copied after the registration step. You will need to check your sequences and move the the file registration to the end.
Answered 10/18/2011 by: jmaclaurin
Third Degree Blue Belt

Please log in to comment
0
Don't use self-registrations for COM-components, add it as advertised instead!
Answered 10/18/2011 by: AngelD
Red Belt

Please log in to comment
0
Thanks for the reply.
Added a batch file to register all the dll's after the reboot.
Answered 10/19/2011 by: Netrock
Orange Senior Belt

Please log in to comment
0
Added a batch file to register all the dll's after the reboot.Do you use a hammer to drive in screws, too? Why not learn how to do the job properly rather reaching for the blunt instrument?
Answered 10/19/2011 by: VBScab
Red Belt

Please log in to comment