Change the ProductName in a custom action...
All..
I would like to change the product name based on when a particular feature is going to be installed.
I added a SetProperty CA to change the value of the ProductName property if &AFeature = 3 but it still is not working.
Any suggestions?
I would like to change the product name based on when a particular feature is going to be installed.
I added a SetProperty CA to change the value of the ProductName property if &AFeature = 3 but it still is not working.
Any suggestions?
0 Comments
[ + ] Show comments
Answers (3)
Please log in to answer
Posted by:
ghosh.kunal
14 years ago
I dont think it is advisable to change the Product Name Property, ever.
Posted by:
happyphunn
14 years ago
It is working now....
I had to CA down a little lower. So, what's weird is that it changes the value ONLY on SOME dialogs during the install. The value in Add/Remove programs still has the value of what is in the property table though.....weird.
I had to CA down a little lower. So, what's weird is that it changes the value ONLY on SOME dialogs during the install. The value in Add/Remove programs still has the value of what is in the property table though.....weird.
Posted by:
anonymous_9363
14 years ago
Perhaps the dialog text is being set explicitly, rather than using the ProductName property.
Rating comments in this legacy AppDeploy message board thread won't reorder them,so that the conversation will remain readable.