/bundles/itninjaweb/img/Breadcrumb_cap_w.png
I have made a network distributionpoint with the network installation wizard that came with the cd.
The installation works fine, the problem starts when starting the application.
A lot of times (especially when the workstation is busy) when I start autocad there appear about 68!!!!!! internet explorer windows which I am only able to close after the close of the open autocad program.
The strange part is that when I install autocad with the cd, I never have the problem.
0 Comments   [ - ] Hide Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.
Answer this question or Comment on this question for clarity

Answers

0
Try recreating your network deployment package, but do not check the "require internet explorer 6" check both during the network installation wizard. That should solve it. Also, make sure IE 6 is already installed as with .NET 1.1
Answered 09/08/2004 by: cdupuis
Third Degree Green Belt

Please log in to comment
0
I have created the network deployment package numerous times.
I always did not check the require internet explorer 6 as I know that IE6 SP1 is automatically installed at every workstation. I do not however install .NET1.1 in advance.
The network deployment package installs .NET1.1 by itself if it is not already installed.
Answered 09/09/2004 by: pa.bruin
Yellow Belt

Please log in to comment
0
how about the installation sequence of the source
Answered 10/21/2008 by: joncena
Yellow Belt

Please log in to comment