Ok, I'd like to think I know what I am doing but I am not getting the results I need. I have some InProc Handler for a few classes that use UTS_Router.exe. I noticed that my setup capture in Wise is not putting in the explicit path to the EXE when I install the MSI. So I located the inproc handlers but I don't want to put an explixit path in the MSI. I've tried using the following as the DefInProcHandler value:

[$UTS_Router.exe]UTS_Router.exe
[UTS_Router.exe]UTS_Router.exe

The bad value before I tried fixing it was just UTS_Router.exe.

The component for the file is UTS_Router.exe and the file table entry is UTS_Router.exe. I have not been able to get the MSI to write out the full path using the values previously mentioned. I am left wondering if you cannot assign dynamic values for the InProcHandler. Any suggestions are welcome.
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

There are no answers at this time
Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

Answer this question or Comment on this question for clarity