Does anyone know how I apply a trasform against an MSI package that issues the foolowing error when ran:
"This installation cannot be run directly launching the MSI package. You must run setup.exe"
I found the error in the tables within the Property section of the MSI, but I can't figure out how to disable it in a transofm, so that it won't check to see how the package is installed.
0 Comments   [ + ] Show Comments


Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.


Check out this tip, it does work...most of the time.''s-ntfs4
Answered 09/10/2004 by: cdupuis
Third Degree Green Belt

Please log in to comment
Have you checked to see if there is an msi embedded in the .exe. You could use a free tool called winrar to extract all files.
Answered 09/10/2004 by: oreillyr
Fifth Degree Brown Belt

Please log in to comment

Most time, the setup.exe starts an .msi with a special Parameter. You just have to find out what this parameter is for your specific Program.
For example, Installshield uses the ISSETUPDRIVEN=1 Parameter

Answered 05/23/2014 by: EbrithilBowser
Fourth Degree Green Belt

Please log in to comment
Answer this question or Comment on this question for clarity