I've been asked to update a local installation of the SAP GUI 620 on our workstations with the following two SAP GUI 620 Patches:


I'll distrbute the patches via SMS and they must run silently.

Problem 1) When I run with the command line %ProgramFilesDir%\SAPPC\NetInst\SAPSETUP.EXE" /Patch:"%PathToPatch%\SEM31A.EXE" /SILENT - I get "The Patch file setupxxxx...exe could not be opened. Please make sure the file exists and is a vaid SAP Front-End-Patch."

I have verified the paths and know that the .exe files are good because I can install them just by running them, whch leads to...

Problem 2) I cannot find a "Silent" switch for these to EXE files.

Any help is greatly appreciated. Thanks in advance!
0 Comments   [ + ] Show Comments


Please log in to comment

There are no answers at this time
Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.


Answer this question or Comment on this question for clarity