Hi,

When i create my MST with the serial number, my program work in trial mode.
I check the the statut of my serial number in the program and it return ?????|?????|?????|???? in place ?????-?????-?????.
My property with my serial number is correct (ISX_SERIALNUM=?????-?????-????).

Could you help me?

Thanks in advance
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
- Have you logged the install, to ensure that a) your transform is being applied and b) if the property value is correct at run-time?
- Are you sure that the product uses the InstallShield-specific ISX_SERIALNUM property in order to set the serial number? Not all of them do.
Answered 11/14/2008 by: VBScab
Red Belt

Please log in to comment
0
I use this command to execute my MSI
msiexec /i XXX.msi TRANSFORMS=XXX.mst /qb and i also test with
msiexec /i XXX.msi ISX_SERIALNUM=????-???-???? /qb

I'm sure that ISX_SERIALNUM is the good property because i checked it in the dialogs view

thanks
Answered 11/14/2008 by: jcb0203
Senior Yellow Belt

Please log in to comment
0
I found the problem.
When i create my proporty, i do a copy/past of the serial number in my value property.
But when i do that, the dashes changed in |.
I put my serial without copy/past and now, it's working.

Thanks
Answered 11/14/2008 by: jcb0203
Senior Yellow Belt

Please log in to comment
Answer this question or Comment on this question for clarity