Patching SAP GUI 6.4 and 6.2 via SAPAdmin
Hi,
I'm using SAPAdmin to create a custom Installation package and run setup.exe /p"Packagename" /SILENT to run the install.
This works fine until I start applying patches to the installer sources via SAPAdmin. When I run the Setup afterwards, I get plenty of files not found after the installer finishes.
I can't find anything in this regard. What am I missing?
I'm using SAPAdmin to create a custom Installation package and run setup.exe /p"Packagename" /SILENT to run the install.
This works fine until I start applying patches to the installer sources via SAPAdmin. When I run the Setup afterwards, I get plenty of files not found after the installer finishes.
I can't find anything in this regard. What am I missing?
0 Comments
[ + ] Show comments
Answers (1)
Please log in to answer
Posted by:
olivier
19 years ago
I
I do the same here. I patched the source, same as you.
where is the prob?
I do the same here. I patched the source, same as you.
where is the prob?
Rating comments in this legacy AppDeploy message board thread won't reorder them,so that the conversation will remain readable.
