Office 2010 Silent installation - product key and activate
I created a self installation of Office 2010 and slipstreamed SP1. I zipped it all up and added it to the post installation tasks. Where do I need to put our Office volume key so it will have a good key on installation and activate on start up?
0 Comments
[ + ] Show comments
Answers (2)
Please log in to answer
Posted by:
RandomITPro
12 years ago
From what I remember, you (can) give Office the key when you make the self installation. I'd run the setup.exe /admin again and check. As it is right now, if you run your post-install script it will hang and ask you for a license key.
Posted by:
cblake
12 years ago
All of the Office config is done in the MSP; so you'll add your key and options in there as Tentacle Master=2>=#0066cb> said.
Take a look at these sites. There's a ton of knowledge here.
K1000 KKE's: https://support.software.dell.com/k1000-systems-management-appliance/kb?k=KKE
Rating comments in this legacy AppDeploy message board thread won't reorder them,so that the conversation will remain readable.
