MapInfo - how do you pass the serial number
Hi all,
Has anyone packaged the latest MapInfo? I can't figure out where/how to pass the serial number.
Thanks,
edoc
Has anyone packaged the latest MapInfo? I can't figure out where/how to pass the serial number.
Thanks,
edoc
0 Comments
[ + ] Show comments
Answers (3)
Please log in to answer
Posted by:
spartacus
18 years ago
Extract from the MapInfo Pro 8.0 Release Notes :
Completely Silent Install
To initiate a silent install:
1. Place the installation CD in the target computer’s disk drive.
2. From the command line on the target computer, type:
"d:\Install\MI_PRO\DISK1\setup.exe" /s /v"/q PIDKEY=MI##############"
So, from the above, the MSI property you need to supply in your repackage/transform is PIDKEY, setting it's value to the serial number you have been given for the product.
Release Notes PDF for MapInfo Pro 8.0 is available at the following link :
http://www.mapinfo.com/documentation/software/mapinfo_pro/english/8.0/MIPro80_RN.pdf
Regards,
Spartacus
Completely Silent Install
To initiate a silent install:
1. Place the installation CD in the target computer’s disk drive.
2. From the command line on the target computer, type:
"d:\Install\MI_PRO\DISK1\setup.exe" /s /v"/q PIDKEY=MI##############"
So, from the above, the MSI property you need to supply in your repackage/transform is PIDKEY, setting it's value to the serial number you have been given for the product.
Release Notes PDF for MapInfo Pro 8.0 is available at the following link :
http://www.mapinfo.com/documentation/software/mapinfo_pro/english/8.0/MIPro80_RN.pdf
Regards,
Spartacus
Posted by:
Rioch
16 years ago
Hi All,
i am trying to creat a transform .mst file for Mapinfo 8.5 .i am using Flexnet Adminstudio tuner and installshield but when i try and creat Response transform it will not except the Serial and will not let me proceed .. has anyone any ideas on what application i can use to create this .mst file ?
i am trying to creat a transform .mst file for Mapinfo 8.5 .i am using Flexnet Adminstudio tuner and installshield but when i try and creat Response transform it will not except the Serial and will not let me proceed .. has anyone any ideas on what application i can use to create this .mst file ?
Rating comments in this legacy AppDeploy message board thread won't reorder them,so that the conversation will remain readable.
