Tried to pxe boot, and it would not connect. Instantly remembered I needed drivers for it to work nice with the KBE.

Any Ideas where to get them?
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Answers

0
If it's UEFI then you will need to boot the KBE from a USB drive.

Here's a guide for the Surface Pro 3. You can use the same concept to add the drivers to the KBE for your need.

https://support.software.dell.com/k2000-systems-deployment-appliance/kb/122905 
Answered 03/30/2015 by: h2opolo25
Red Belt

  • I already have the usb kbe and that works fine, but I was using a different usb to eth device and dont have drivers for it.

    The big issue is that I only have 1 usb 3.0 port. I need to use a usb hub and a usb to eth and the usb kbe. We recently purchased a device from Dell that is a USB 3.0 to vga/HDMI/Eth/usb2.0 and it will not boot using the known working usb KBE. if I switch back to the hub, usb to eth, and usb kbe it works fine. thus I came to the conclusion that was the same issue I was having before I added the drivers for the usb to eth, and need the drivers for this new device.
  • The following is the Device.

    http://accessories.us.dell.com/sna/productdetail.aspx?c=us&l=en&s=dhs&cs=19&sku=470-ABHH
Please log in to comment
Answer this question or Comment on this question for clarity