Has anyone been successful with this installation from their KBOX?

I cannot seem to get this working and I have tried numerous methods.

- Unpackaged the full install down to the setup.exe then ran with /qb /norestart
- http://social.msdn.microsoft.com/Forums/en-US/netfxsetup/thread/04898a11-ba1d-4542-be39-0879453e9741

Any suggestions?

A.C. McCoppin
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
It's unclear what's going on here...are you doing .NET as a post-install task on a particular scripted install?
Answered 10/07/2009 by: jkatkace
Purple Belt

Please log in to comment
0
I am not aware of any other way I would be installing it using command line parameters other than a post-installation task. But it is used as a scripted install or an Image. Once configured, both should work interchangeably.
Answered 10/07/2009 by: amccoppin
Senior Yellow Belt

Please log in to comment
Answer this question or Comment on this question for clarity

Share