As per the client requirement, we need to disable one FEATURE. Following steps are tried:

1) Went to Installation Expert. Right Click on the particular feature and selected "Never install this feature". That means made the InstallLevel of the Feature to 0.

2) Kept the InstallLevel of the feature more than that of the InstallLevel of the package.

The above two steps were tried but it did not work.

Kindly suggest any other method.
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
There is no other method. Take a verbose log of the install. My bet is that a Custom Action is overriding your setting(s).
Answered 06/03/2009 by: VBScab
Red Belt

Please log in to comment
0
check the condition table. this is used to change the value of the FeatureLevel during installation based on specified conditions.
Answered 06/03/2009 by: jmcfadyen
Fifth Degree Black Belt

Please log in to comment
Answer this question or Comment on this question for clarity