I am trying to add a checkbox to a dialog but am having problems.

The checkbox has a property called Accepted which is set to 0 and its Check Value is set to 1

The finish button is disabled by default and its conditions are set as Disable if Accepted<>1, Enable if Accepted=0 and Enable on WiseUninstall

The problem is that the checkbox starts Checked and the Finish button is disabled. I have to clear the checkbox and check it again to enable the finish button.

Does anybody have any idea what the problem is?
0 Comments   [ + ] Show Comments

Comments

Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.

Answers

0
Checkbox by default is enabled, you cannot probably change this but ya you can definitely try to reverse your logic at this time. I had same issue long back but it was resolved once i reversed the logic.
Answered 05/31/2005 by: wiseapp
Second Degree Green Belt

Please log in to comment
Answer this question or Comment on this question for clarity