I know i searched everywhere, found examples, and still can't seem to get the right fix.
I am trying to install the below patch via this command:
start /wait msiexec /p Ac60PrP1.msp REINSTALLMODE=omus REINSTALL=ALL REBOOT=ReallySuppress /qb

The update stops and is looking for the original source "acropro.msi" on a network drive that no longer exists.

I tried changing the installsource in the registry, but everytime i try this, it still is looking for the drive\source that no longer exists.

How do I get around this....I have to update over 400 desktops and don't want to have to manually point to the new location of the acropro.msi
0 Comments   [ + ] Show Comments


Please log in to comment

Rating comments in this legacy AppDeploy message board thread won't reorder them,
so that the conversation will remain readable.


This article explains why the source is needed:


I think that if you change the sourcelocations in HKCR\Installer\... you could pull it off (I haven't tested it).
Answered 09/19/2005 by: Ilikebananas
Purple Belt

Please log in to comment
/qb (basic) reguire the MSI to show dialogs as there are no dialogs in an MSP file
try use /qn instead
Answered 09/20/2005 by: AngelD
Red Belt

Please log in to comment
Answer this question or Comment on this question for clarity